Welcome Products Services Support Upgrades Repairs VirusInfo FindIt
When done with this page, click one of the above tabs.
•   Starting Over
   How to clean, reformat
   and reload your
   computer's hard drive.
•   Modem Problems
   How to detect and
   repair some of your
   modem problems.
•   Computer Faxing
   How to send and
   receive faxes with
   your computer.
•   Make A Boot Disk
   How to make an
   emergency boot disk.
•   Virus Protection
   How to keep your
   computer bug free.
•   Removing Files
   How to safely remove
   files & programs from
   your hard drive.
•   Installing Software
   How to install new
   programs in
   your computer.
•   Don't Install This
   A few things that
   probably shouldn't be
   installed in your
   computer.
•   Re-Formating
   How to properly reformat
   your hard drive.
•   Under The Hood
   How to safely work inside
   your computer.
•   Re-Associate Files
   Re-associate an
   "Open-With" to a
   file type.
•   Using A Scanner
   How to make your
   scanner do
   what you want.
•   Computer Crashes
   Why some computers
   crash, hang or freeze.
•   How To Save Files
   Saving & retrieving
   files to and from
   your hard drive.
•   Copy & Paste
   How to use the
   most powerful tool
   in Windows.

"My customers receive free lifetime support"



Under the Hood of Your Computer


Please read the disclaimer at the end of this page, before preforming this procedure.

Before you take the cover off of your computer please read the following. There are several safety issues that will minimize the chances of hurting yourself or your computer.

A computer, with its cover on, is a remarkably robust device. It is very difficult to mishandle a modern computer, from the outside, in such a way as to cause damage to the internal components.

Opening the computer exposes both it and you to a myriad of hazards. From nasty cuts from very sharp edges on the sheet metal and circuit cards, to potentially lethal high voltage inside the power supply and its power switch, there are numerous ways to hurt or kill yourself. Over 300 volts can be found inside the power supply of most computers. Most color monitors have areas of over 20,000 volts inside, even when they are turned off and unplugged. Other computer peripherals such as printers, scanners, etc. can also have hazardous areas inside them.

Even with all the dangers to you, it is far more likely you will hurt the computer, than it will hurt you. Improperly handling or installing a card in the computer can cause damage to it or other components. Misalignment of a card in its socket can cause the card or motherboard, or both, to expire the instant power is applied. Simply mishandling an internal component can cause problems. Fingerprints on connectors can cause intermittent trouble, simply touching certain cards, after walking across the floor can transfer enough static electricity to ruin or prematurely age the component. Static electricity, even so low that you can't feel it, can wreck havoc with today's large-scale microelectronics.

All computer boards should be left in their anti-static bags until just before you install them in the computer. You should insure your body is connected to a good ground through a >1 Megohm resistance. Use a professional wrist type grounding-strap, not a homemade device. Improper grounding of yourself could cause a lethal shock hazard.

In my, 20 years plus, in the computer business I have seen thousands of computer problems created by the improper handling and installation of circuit boards, hard drives, CD-ROMs, modems, and other devices. Many computer professionals don't even fully understand the proper care and handling of the parts inside a computer, and by their ignorance, mishandle a part that should run for over ten years and reduce its life span to less than one year.




Points To Remember

  • Use an Approved Ground Strap:
    Never use a homemade ground strap. Improper ground straps can pose a shock hazard.
  • Leave Parts in their Anti-Static containers until ready to Install:
    Never open or examine new computer parts unless you are properly grounded. Never hand a part to anyone that is not also properly grounded. Never leave unprotected parts out on a table where someone can walk by and pick it up.
  • Turn the Computer Off:
    Many modern computers are never completely off. Check the back of your computer, near the power cord, for a power switch. If your computer has one, turn it OFF while you are adding or removing components.

    If your computer has no rear power switch, plug your computer into a power-strip, leave the strip OFF but plugged into a grounded outlet.

    Having your computer plugged into a grounded outlet but completely powered off, offers a path to ground for any static zaps. Remember to turn the power switch(es) back on before you restart your computer.

  • Don't run your computer with the covers off:
    Computers are not properly protected from static zaps "ESD" without their covers. Computers are designed for best cooling airflow with their covers in place. An uncovered computer can overheat.



    Please See This...

    Especially the sidebars, for more about working with the internal components in your computer.



    If you have any doubts about your abilities to properly handle and install circuit boards, hard drives, and so forth, in your computer, Please contact a competent technician. Finding and identifying a proficient technician can be a real challenge, just because they may work in a computer store or can pronounce "Peripheral" does not assure they know what they are doing. Ask them how many thousands of computers they have serviced, and how many years they have worked in the computer industry, 10 years is a good start, more is even better.

    Good luck, and please be careful. J.R. Whipple





    Use the above procedure at your own risk!
    J.R. has been building and repairing computers for over 20 years, and has personally used the above procedure on thousands of computers. Each computer is different and the competence of the user can vary.   J.R. Whipple, in no way warrants the above procedure, nor can he be held responsible for any problems, loss of data, loss of business, or any other damages caused by the application of the above procedure. If you are not comfortable with the above procedure, DON'T DO IT. If you need help please Contact Us before attempting the above procedure.

  • Virus Info
    To learn all about computer viruses, or check you computer for viruses, click the above icon.

    No mass-produced computers. I hand- craft each of my computer systems.


    Return to the main page.

    ...
    About J.R. Whipple
    •   The Company
    •   The Person
    Maps & Pictures
    •   Maps & Directions to Us
    •   Pictures from the Lab
    Contact Us
    •   Email & Snail-Mail
    •   Phone & Fax numbers
      Set a Bookmark or Favorite Now, So You Can Easily Find This Page in the Future  

    Copyright © 2000, J.R. Whipple & Associates